Ex-11

SRS DTC Troubleshooting: Ex-11

DTC Ex-11 ("x" can be 0 thru 9 or A thru F):

Control Operation Recorded

NOTE:

- Before doing this troubleshooting procedure, find out if the vehicle was in a collision. If so, verify that all the required components were replaced with new components, of the correct part number, and that they were properly installed Service and Repair.
- Before doing this troubleshooting procedure, review SRS Precautions and Procedures Technician Safety Information and General Troubleshooting Information Reading and Clearing Diagnostic Trouble Codes.

1. Clear the DTC memory Reading and Clearing Diagnostic Trouble Codes.

2. Turn the ignition switch to ON (II), then wait for 10 seconds.

3. Read the DTC Reading and Clearing Diagnostic Trouble Codes.

Is DTC Ex-11 indicated?

YES -

Faulty SRS unit; replace the SRS unit SRS Unit Replacement.�

NO -

Intermittent failure, the system is OK at this time. Go to Troubleshooting Intermittent Failures Reading and Clearing Diagnostic Trouble Codes. If another DTC is indicated, troubleshoot the DTC.�