62-2x

SRS DTC Troubleshooting: 62-2x

DTC 62-2x ("x" can be 0 thru 9 or A thru F):

Short in the Front Passenger's Seat Belt Buckle Switch

NOTE: Before doing this troubleshooting procedure, review SRS Precautions and Procedures Service and Repair and General Troubleshooting Information Reading and Clearing Diagnostic Trouble Codes.

1. Clear the DTC memory Reading and Clearing Diagnostic Trouble Codes.

2. Turn the ignition switch to LOCK (0), then wait for 10 seconds.

3. Turn the ignition switch to ON (II), then buckle and un-buckle the front passenger's seat belt several times.

4. Read the DTC Reading and Clearing Diagnostic Trouble Codes.

Is DTC 62-2x indicated?

YES -

Go to step 5.

NO -

Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures Reading and Clearing Diagnostic Trouble Codes. If another DTC is indicated, troubleshoot the DTC.�

5. Turn the ignition switch to LOCK (0).

6. Disconnect the floor wire harness 3P connector (A) from the front passenger's seat belt buckle switch 3P connector.






7. Turn the ignition switch to ON (II).

8. From the system selection menu on the HDS, select SRS, then select SRS again, then select PARAMETER INFORMATION, then Buckle Switch. Seat Position Sensor, and check the status on the HDS screen for FRONT RIGHT SEAT BELT BUCKLE SWITCH.

Is OPEN indicated on the HDS?

YES -

Faulty front passenger's seat belt buckle switch; replace the front passenger's seat belt buckle assembly Front Seat Belt Replacement, then clear the DTC.�

NO -

Short to ground in the floor wire harness; replace the floor wire harness, then clear the DTC.�