Intake Manifold Removal/Installation

Intake Manifold Removal and Installation

Exploded View

J35Z2 engine





Exploded View

J35Z3 engine





Removal

1. Remove the strut brace Frame Brace Replacement.

2. Remove the engine cover.






3. Disconnect the manifold absolute pressure (MAP) sensor connector (A) and the breather pipe (B), and remove the intake air duct (C).






4. J35Z2 engine: Disconnect the throttle actuator connector (A), the evaporative emission (EVAP) canister purge valve connector (B), the water bypass hoses (C), the EVAP hose (D), and the brake booster vacuum hose (E).






5. J35Z3 engine: Disconnect the throttle actuator connector (A), the EVAP canister purge valve connector (B), the water bypass hoses (C), the EVAP hose (D), the brake booster vacuum hose (E), and the vacuum hose (F).






6. J35Z2 engine: Disconnect the positive crankcase ventilation (PCV) hose (A), then remove the upper cover mounting bolts and nuts sequentially in three steps, then remove the upper cover (B).






7. J35Z3 engine: Disconnect the PCV hose (A) and the intake manifold tuning (IMT) actuator connector (B), then remove the upper cover mounting bolts and nuts sequentially in tree steps, then remove the upper cover (C).






8. Remove the intake manifold mounting bolts and nuts sequentially in three steps, then remove the intake manifold.






Installation

1. Install the intake manifold. Tighten the bolts and nuts sequentially in three steps. Always use a new intake manifold gasket.










2. J35Z2 engine: Install the upper cover (A). Tighten the bolts and nuts sequentially in three steps. Always use a new gasket, then connect the PCV hose (B).










3. J35Z3 engine: Install the upper cover (A). Tighten the bolts and nuts sequentially in three steps. Always use a new gasket, then connect the PCV hose (B) and the IMT actuator connector (C).










4. J35Z2 engine: Connect the throttle actuator connector (A), the EVAP canister purge valve connector (B), the water bypass hoses (C), the EVAP hose (D), and the brake booster vacuum hose (E).






5. J35Z3 engine: Connect the throttle actuator connector (A), the EVAP canister purge valve connector (B), the water bypass hoses (C), the EVAP hose (D), brake booster vacuum hose (E), and the vacuum hose (F).






6. Install the intake air duct (A), then connect the breather pipe (B) and the MAP sensor connector (C).





7. Clean up any spilled engine coolant.

8. After installation, check that all tubes, hoses, and connectors are installed correctly.

9. Install the engine cover.





10. Install the strut brace Frame Brace Replacement.

11. Refill the radiator with engine coolant, and bleed the air from the cooling system Service and Repair.