Charging System Indicator Circuit Troubleshooting
Charging System Indicator Circuit Troubleshooting
NOTE:
- If the 12 V battery voltage is too low to operate the starter motor, the charging system indicator may come on.
- If the charging system indicator stays on or never comes on, do this troubleshooting (if no DTC's are set).
1. Turn the ignition switch to ON (II).
2. Check for Temporary DTCs or DTCs with the HDS.
Are any Temporary DTCs or DTCs indicated?
YES - Go to the indicated DTC's troubleshooting.
NO - Go to step 3.
3. Turn the ignition switch to LOCK (0).
4. Check the 12 V battery. Testing and Inspection
Is the 12 V battery OK?
YES - Go to step 5.
NO - Charge or replace the 12 V battery.
5. Turn the ignition switch to ON (II).
6. Check the HISTORY OF DC-DC CONVERTER STOP and the HISTORY OF IPU MODULE FAN STOP with the HDS.
Does the screen indicate OFF?
YES - Go to step 7.
NO - Intermittent failure, the system is OK at this time.
7. Turn the ignition switch to ON (II), and watch the charging system indicator.
Does the charging system indicator come on?
YES - Go to step 8.
NO - Do the gauge self-diagnostic function. Initial Inspection and Diagnostic Overview
8. Start the engine, and watch the charging system indicator.
Does the charging system indicator go off?
YES - The charging system indicator circuit is OK.
NO - Go to step 9.
9. Do the gauge self-diagnostic function. Initial Inspection and Diagnostic Overview
Does the charging system indicator flash?
YES - Go to step 10.
NO - Substitute a known-good gauge control module (tach), and recheck. If the charging system indicator circuit is OK, replace the original gauge control module. Gauge Control Module Replacement
10. Run the engine at idle for 2 minutes.
11. Check for Temporary DTCs or DTCs with the HDS.
Are any Temporary DTCs or DTCs indicated?
YES - Go to the indicated DTC's troubleshooting.
NO - Go to step 12.
12. Watch the charging system indicator.
Does the charging system indicator go off?
YES - The IMA battery was in temporary shut down mode, due to temperature extremes.
NO - Go to step 13.
13. Check the MPI VOLTAGE in the DATA LIST with the HDS.
Is about 99-210 V indicated?
YES - Check the connections of the DC-DC converter.
NO - Replace the DC-DC converter. Service and Repair