Tighting Torques and Sequences

Cylinder Head Torque and Sequence

Tighten the cylinder head bolts in sequence to 29 N-m (3.0 kgf-m, 22 lbf-ft).





Tighten all cylinder head bolts an additional 130 °.






Head Bolt Reuse/Replace

If either diameter is less than 10.6 mm (0.42 in.), replace the cylinder head bolt.






Intake Manifold Assembly

Tighten the bolts/nuts in a crisscross pattern in three steps, beginning with the inner bolt.






Camshaft Bearing Caps
Tighten each bolt two turns at a time in sequence.
Camshaft Holder/Lost Motion Holder, 8mm to 22 N-m (2.2 kgf-m, 16 lbf-ft)
Rocker Shaft, 8mm to 20 N-m (2.0 kgf-m, 16 lbf-ft)
Camshaft Holder, 6mm to 12 N-m (1.2 kgf-m, 8.7 lbf-ft)






Camshaft Sprocket
Tighten the bolt to