SRS Unit Replacement

SRS Unit Replacement

Removal

NOTE: If you are only disconnecting SRS unit connector A, skip step 2.

1. Do the battery terminal disconnection procedure, Procedures then wait at least 3 minutes before starting work.

2. Disconnect both seat belt tensioner 4P connectors Technician Safety Information and both seat belt buckle tensioner 4P connectors. Technician Safety Information

3. Remove the center console. Center Console Removal/Installation

4. Disconnect SRS unit connector A (28P), B (28P), and remove the TORX bolts (C), then pull out the SRS unit.






Installation

1. Install the SRS unit (A) with new TORX bolts (B), then connect the connectors (C) to the SRS unit; push them into position until they click.
NOTE: Be sure the SRS unit is sitting squarely against its bracket before torquing the TORX bolt.

2. Do the battery terminal reconnection procedure. Procedures

3. Calibrate the ODS unit. Programming and Relearning

4. Do the ODS unit operation check. ODS Unit Operation Check

5. Confirm proper SRS system operation: Turn the ignition switch to ON (II); the SRS indicator should come on for about 6 seconds and then go off.

6. Reinstall all removed parts.