Backup Lamp Switch: Testing and Inspection

Back-up Light Switch Test

NOTE: Use fender covers to avoid damaging painted surfaces.

1. Remove the clip (A), then remove the air duct (B)

2. Do the battery removal procedure. Removal and Replacement

3. Remove the air cleaner assembly. Service and Repair






4. Remove the battery base bolts (A), loosen the two bolts (B), remove the cable clamps (C), then remove the battery base (D).






5. Disconnect the back-up light switch 2P connector (A).






6. Check for continuity between the back-up light switch 2P connector terminals No. 1 and No. 2. There should be continuity only when the shift lever is in reverse.






7. Remove the back-up light switch (A). Check for continuity between back-up light switch 2P connector terminals No. 1 and No. 2. There should be continuity when the switch end (B) is pressed, and no continuity when the switch end is released. If the result is faulty, replace the back-up light switch. If the switch is OK, check the reverse shift piece in the transmission.

8. Apply liquid gasket (P/N 08717-0004, 08718-0001, 08718-0012, 08718-0003, or P/N 08718-0009) to the threads of the back-up light switch, and install it on the transmission housing.

9. Connect the back-up light switch 2P connector.











10. Install the battery base (A) and the cable clamps (B).

11. Install the air cleaner assembly. Service and Repair

12. Do the battery installation procedure. Removal and Replacement






13. Install the air duct (A) and the clip (B).