Trim Removal/Installation - Trunk Area

Trim Removal/Installation - Trunk Area

Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the Honda Tool and Equipment Program.

NOTE:
- Put on gloves to protect your hands.
- Take care not to bend or scratch the trim and panels.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Pull the trunk floor (A) up, then remove the trunk tool box (B).






2. While pushing both hooks (A) down with your hands, pull the trunk floor (B) back to release these hooks from the holes (C) in the trunk front trim panel (D), then remove the trunk floor.






3. Remove the trunk lid weatherstrip near the trunk rear trim panel.
4. Detach the clips, and release the hooks (A) by pulling the trunk rear trim panel (B) up, then remove it.






5. Remove the clips securing the trunk front trim panel (A), and using a trim tool, remove the caps (B), and remove the nuts securing the trunk partition (C).






6. Fold both side edges of the trunk front trim panel (A), then remove the trunk front trim panel and trunk partition (B) as an assembly.






7. If necessary, remove the clips, then separate the trunk front trim panel (A) and trunk partition (B).






8. Remove the clips, then remove the trunk side trim panel (A).






9. Install the trim in the reverse order of removal, and note these items:
- Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
- Push the clips into place securely.