Flywheel Housing Disassemble & Service
Final Drive Shaft Bearing ReplacementSpecial Tools Required
^ Adjustable bearing puller, 25-40 mm
07736-A01000B or 07736-A01000A
^ Attachment, 62 x 68 mm 07746-0010500
^ Driver 07749-0010000
1. Remove the final drive shaft bearing (A) using the adjustable bearing puller, 25-40 mm and a commercially available 3/8"-16 UNF slide hammer (B).
2. Install a new bearing into the flywheel housing using the driver and the attachment, 62 x 68 mm.
Input Shaft Oil Seal Replacement
Special Tools Required
^ Attachment, 37 x 42 mm 07746-0010200
^ Driver 07749-0010000
1. Remove the input shaft oil seal from the flywheel housing.
2. Install a new oil seal flush with 3±0.5 mm (0.12±0.02 in.) (A) below flywheel housing level. Using the driver and the attachment, 37 x 42 mm.
