Trim Removal/Installation - Door Areas

Trim Removal/Installation - Door Areas

Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the Honda Tool and Equipment Program.

Front Door Sill Area

NOTE:
- Put on gloves to protect your hands.
- Take care not to bend or scratch the trim and the panels.
- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.

1. Driver's side: Remove the footrest.
2. Driver's side: Remove the front side cap from the front door sill trim, and remove the opener lock cylinder and screw.
3. Detach the hooks (A) and the tabs (B) from the kick panel (C) and the B-pillar lower trim (D), and pull the front door sill trim (E) up by hand to detach the clips (F, G), then remove it.









4. Pull out the front door opening seal (A) from the trim hooks (B) and around the front door opening flange, then remove the seal.






5. Pull the driver's kick panel (A) or the passenger's kick panel (B) back by hand to detach the clips (C, D), then remove them.









6. Install the trim in the reverse order of removal, and note these items:
- Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
- Push the clips and the hooks into place securely.

Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the Honda Tool and Equipment Program.

Rear Door Sill Area

NOTE:
- Put on gloves to protect your hands.
- Take care not to bend or scratch the trim and the panels.
- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.

1. Detach the hook (A) and the tab (B) from the B-pillar lower trim (C), and pull the rear door sill trim (D) up by hand to detach the clips, then remove it.






2. Pull the rear seat cushion (A) up to release the hook (B). While pulling the cushion up, detach the clips and remove the rear door sill trim (C) from the rear door opening seal (D).






3. Pull out the rear door opening seal (A) from the trim hooks (B) and around the rear door opening flange, then remove the seal.






4. Install the trim in the reverse order of removal, and note these items:
- Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
- Push the clips and the hooks into place securely.