Trunk / Liftgate Release Lever: Service and Repair
Trunk Lid Opener/Fuel Fill Door Opener ReplacementSpecial Tools Required
KTC trim tool set SOJATP2014 *
* Available through the Honda Tool and Equipment Program.
NOTE: Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
1. Pry out the bottom edge of the front side cap (A) at the notch with the trim tool to detach the hooks (B), and release the hooks (C), then remove the cap from the front door sill trim (D).
2. Remove the opener lock cylinder (E), and loose the bolt.
3. Remove the screw securing the front door sill trim (A) and the trunk lid opener/fuel fill door opener.
4. Remove the front door sill trim.
5. Remove the bolt, then remove the trunk lid opener/ fuel fill door opener (A) from the bolt (B).
6. Disconnect the trunk lid opener/fuel fill door opener cable (A), then remove the opener (B). Take care not to kink the cable.
7. Install the opener in the reverse order of removal, and note these items:
- Make sure the opener cable is connected properly.
- Make sure the trunk lid and the fuel fill door open properly and lock securely.
- Securely attach the outer end of the cable back to its original installed position on the trunk lid opener/fuel fill door opener, then check the trunk lid latch operation: Make sure the trunk lid latch, and the fuel fill door latch unlock when pulling and pushing the trunk lid opener/fuel fill door opener. If necessary, readjust the position of the cable end.