Trunk / Liftgate Latch: Service and Repair
Trunk Lid Latch Replacement1. Remove the trunk lid trim.
2. Disconnect the cylinder rod from the lock cylinder.
3. Disconnect the trunk lid opener cable (A), and disconnect trunk lid latch switch connector (B). Take care not to bend the opener cable.
4. Remove the bolts from the trunk lid latch (A).
5. Pull the trunk lid latch (A) out, and disconnect the cylinder rod (B) from the trunk lid latch. Take care not to bend the cylinder rod.
NOTE: Check for a damaged or stress-whitened rod fastener (C).
6. Install the latch in the reverse order of removal, and note these items:
- Replace the rod fastener if it is damaged.
- Make sure the connector is plugged in properly and the opener cable is connected properly.
- Make sure the trunk lid opens properly and locks securely.
- Securely attach the outer end of the cable (A) back to its original installed position on the trunk lid latch, then check the trunk lid latch operation: Make sure the trunk lid latch unlock when pulling the trunk lid opener/fuel fill door opener. If necessary, readjust the position of the cable end.
