DTC Troubleshooting
DTC P1286: Rocker Arm Oil Pressure Sensor Stuck LowSpecial Tools Required
- Pressure gauge adapter 07NAJ-P07010A
- A/T low pressure gauge w/panel 07406-0070301
- A/T pressure hose 07406-0020201
- A/T pressure hose, 2,210 mm 07MAJ-PY4011A
- A/T pressure adaptor 07MAJ-PY40120
- Oil pressure hose 07ZAJ-S5AA200
NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information.
1. Turn the ignition switch OFF.
2. Check the engine oil level.
Is the level OK?
YES - Go to step 3.
NO - Adjust the engine oil to the proper level, then go to step 14.
3. Turn the ignition switch ON (II).
4. Clear the DTC with the HDS.
5. Do the VTEC TEST in the INSPECTION MENU with the HDS.
Is the result OK?
YES - Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at rocker arm oil control solenoid 1, rocker arm oil control solenoid 2, the rocker arm oil pressure switch, the rocker arm oil pressure sensor, and the PCM.
NO - Go to step 6.
6. Turn the ignition switch OFF.
7. Remove the rocker arm oil pressure sensor (A), and install the special tools as shown, then attach the rocker arm oil pressure sensor to the pressure gauge adapter (B).
NOTE: Install the parts in the reverse order of removal with a new O-ring.
8. Reconnect the rocker arm oil pressure sensor 3P connector.
9. Start the engine.
10. Note the value of the ROCKER ARM OIL PRESSURE SENSOR in the DATA LIST with the HDS.
11. Compare the value of the ROCKER ARM OIL PRESSURE SENSOR and the value of the oil pressure gauge.
Are they the same values?
YES - Check the VTEC system oil line, then go to step 12.
NO - Replace the rocker arm oil pressure sensor, then go to step 12.
12. Turn the ignition switch OFF.
13. Reconnect all connectors.
14. Turn the ignition switch ON (II).
15. Reset the PCM with the HDS.
16. Do the PCM idle learn procedure.
17. Do the VTEC TEST in the INSPECTION MENU with the HDS.
18. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P1286 indicated?
YES - Check for poor connections or loose terminals at rocker arm oil control solenoid 1, rocker arm oil control solenoid 2, the rocker arm oil pressure switch, the rocker arm oil pressure sensor, and the PCM, then go to step 1.
NO - Go to step 19.
19. Monitor the OBD STATUS for DTC P1286 in the DTCs MENU with the HDS.
Does the screen indicate PASSED?
YES - Troubleshooting is complete. If any other Temporary DTCs or DTCs were indicated in step 18, go to the indicated DTCs troubleshooting.
NO - If the screen indicates FAILED, check for poor connections or loose terminals at rocker arm oil control solenoid 1, rocker arm oil control solenoid 2, the rocker arm oil pressure switch, the rocker arm oil pressure sensor, and the PCM, then go to step 1. If the screen indicates EXECUTING, keep testing until a result comes on. If the screen indicates OUT OF CONDITION, go to step 17.