Continuously Variable Transmission

DTC P0335: Crankshaft Position (CKP) Sensor No Signal

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot with the HDS, and review General Troubleshooting Information.

1. Turn the ignition switch to ON (II).
2. Clear the DTC with the HDS.
3. Start the engine, shift the shift lever in D, while pressing the brake pedal, and let the engine idle for at least 30 seconds.
4. Check for Temporary DTCs or DTCs in the PGM-FI SYSTEM with the HDS.

Is DTC P0335 indicated in the PGM-FI SYSTEM?

YES - Go to the DTC P0335 troubleshooting in the PGM-FI System.

NO - Go to step 5.

5. Check for Temporary DTCs or DTCs in the A/T SYSTEM with the HDS.

Is DTC P0335 indicated in the A/T SYSTEM?

YES - Go to step 6.

NO - Intermittent failure, the system is OK at this time. If any other Temporary DTCs or DTCs were indicated, go to the indicated DTC's troubleshooting.

6. Update the PCM if it does not have the latest software, or substitute a known-good PCM.
7. Start the engine, shift the shift lever to D, while pressing the brake pedal, and let the engine idle for at least 2 minutes.
8. Check for Temporary DTCs or DTCs the A/T SYSTEM with the HDS.

Is DTC P0335 indicated in the A/T SYSTEM?

YES - Check for poor connections or loose terminals at the PCM. If the PCM was updated, substitute a known-good PCM, then go to step 7. If the PCM was substituted, go to step 1.

NO - Go to step 9.

9. Monitor the OBD STATUS for P0335 in the DTCs MENU with the HDS.

Does the HDS indicate PASSED?

YES - If the PCM was updated, troubleshooting is complete. If the PCM was substituted, replace the original PCM. If any other Temporary DTCs or DTCs were indicated in step 8, go to the indicated DTC's troubleshooting.

NO - If the HDS indicates FAILED, check for poor connections or loose terminals at the PCM. If the PCM was updated, substitute a known-good PCM, then go to step 7. If the PCM was substituted, go to step 1. If the HDS indicates NOT COMPLETED, go to step 7.