Transmission Fluid Inspection and Replacement
Transmission Fluid Inspection and ReplacementNOTE: Use fender covers to avoid damaging painted surfaces.
1. Raise the vehicle on a lift.
2. Remove the splash shield.
3. Remove the check bolt (A) and sealing washer (B). Check the condition of the fluid and make sure it is at the proper level (C). If the fluid is dirty, remove the drain plug (D) and sealing washer (E).
4. Install the drain plug with a new sealing washer.
5. Lower the vehicle on the lift then remove the filler plug (A) and washer (B).
6. Refill the fluid from the filler plug hole on the transmission, until the transmission fluid overflows from the check bolt hole (A).
7. Raise the vehicle on a lift. After the fluid stops overflowing, install the check bolt (B) with a new washer (C).
Fluid Capacity:
2.2 L (2.3 US qt) at fluid change
2.5 L (2.6 US qt) at overhaul
Always use Honda Manual Transmission Fluid (MTF).
8. Install the splash shield, then lower the vehicle on the lift.
9. Install the filler plug (A) with a new sealing washer (B).
