Transmission Position Sensor/Switch: Testing and Inspection

Transmission Range Switch Test

1. Do the battery removal procedure.
2. Remove the air cleaner assembly.
3. Remove the 6 x 1.0 mm bolt securing the resonator bracket under the battery base bracket from under the bracket, and remove the battery base and battery base bracket in the engine compartment.
4. Disconnect the transmission range switch connector.





5. Check for continuity between terminals at the switch connector. There should be continuity between the terminals in the following table for each switch position.





6. Transmission range switch test is finished if the test results are OK. If there is no continuity between any terminals, check that the transmission range switch installation. If the switch installation is OK, replace the switch.
7. Install the battery base bracket and battery base, and secure the resonator bracket under the battery base bracket with the bolt from under the bracket.
8. Install the air cleaner assembly.
9. Do the battery installation procedure.