A/T Clutch Pressure Control Solenoid Valve A Replacement
A/T Clutch Pressure Control Solenoid Valve A Replacement1. Remove the intake air duct.
2. Disconnect the A/T clutch pressure control solenoid valve A connector.
3. Remove the bolts securing the ATF cooler inlet line brackets (B).
4. Remove the mounting bolts and A/T clutch pressure control solenoid valve A.
5. Remove the ATF pipe (C), the ATF joint pipes (D), the O-rings (E), and the gasket (F).
6. Clean the mounting surface and fluid passages of the transmission housing.
7. Install a new gasket on the transmission housing, and install the ATF pipe and the ATF joint pipes.
NOTE: Be sure to install a new gasket with the blue side toward the transmission housing.
8. Install new O-rings over the ATF joint pipes.
9. Install a new A/T clutch pressure control solenoid valve A.
10. Secure the ATF cooler inlet line brackets with the bolts.
11. Check the A/T clutch pressure control solenoid valve A connector for rust, dirt, or oil, and clean if necessary, then connect the connector securely.
12. Install the intake air duct.