Removal and Replacement

Starter Removal and Installation

Removal

1. Do the battery removal procedure.
2. Remove the intake manifold.
3. Disconnect the starter cable (A) from the B terminal, and disconnect the BLK/WHT wire (B) from the solenoid S terminal.






4. Remove the harness clamp (C).
5. Remove the two bolts (A) securing the starter, then remove the starter.






Installation

1. Install the starter, then tighten the two bolts.






2. Install the harness clamp (A).






3. Install the starter cable (B) to the B terminal and the BLK/WHT wire (C) to the solenoid S terminal. Make sure the crimped side of the ring terminal faces away from the starter when you connect it.
4. Install the intake manifold.
5. Do the battery installation procedure.
6. Start the engine to make sure the starter works properly.