Seat Position Sensor: Service and Repair
Driver's Seat Position Sensor ReplacementRemoval (Power seat)
NOTE:
- Removal of the driver's seat position sensor must be done according to Precautions and Procedures.
- Do not turn the ignition switch to ON (II), and do not connect the battery cable while removing the driver's seat position sensor.
1. Raise the seat all the way up.
2. Do the battery terminal disconnection procedure, then wait for 3 minutes before starting work.
3. Remove the driver's seat assembly.
4. Disconnect the driver's seat wire harness 2P connector (A) from the driver's seat position sensor.
5. Remove the nut (B), then remove the driver's seat position sensor.
Installation (Power seat)
NOTE:
- Be sure to install the harness so it does not pinched or interfere with other parts.
- Do not turn the ignition switch to ON (II), and do not connect the battery cable while installing the driver's seat position sensor.
1. Install the driver's seat position sensor with a nut (A), then connect the driver's seat wire harness 2P connector to the driver's seat position sensor (B).
2. Reinstall the driver's seat assembly.
3. Do the battery terminal reconnection procedure.
4. Check the operation of the driver's seat position sensor with the HDS.
Removal (Manual seat)
NOTE:
- Removal of the driver's seat position sensor must be done according to Precautions and Procedures.
- Do not turn the ignition switch to ON (II), and do not connect the battery cable while removing the driver's seat position sensor.
1. Raise the seat all the way up.
2. Do the battery terminal disconnection procedure, then wait for 3 minutes before starting work.
3. Remove the driver's seat assembly.
4. Remove the recline cover.
5. Disconnect the seat position sensor harness 2P connector (A) from the driver's seat position sensor.
6. Using a TORX T30 bit, remove the TORX bolt (B), then remove the driver's seat position sensor.
Installation (Manual seat)
NOTE:
- Be sure to install the harness so it does not pinched or interfere with other parts.
- Do not turn the ignition switch to ON (II), and do not connect the battery cable while installing the driver's seat position sensor.
1. Install the driver's seat position sensor with a new TORX bolt (A), then connect the seat position sensor harness 2P connector to the driver's seat position sensor (B).
2. Install the recline cover.
3. Install the driver's seat assembly.
4. Do the battery terminal reconnection procedure.
5. Check the operation of the driver's seat position sensor with the HDS.