ODS Unit Replacement

ODS Unit Replacement

Removal

1. Do the battery terminal disconnection procedure, then wait for 3 minutes before starting work.
2. Disconnect the passenger's side airbag harness 2P connector.
3. Remove the front passenger's seat assembly and seat-back cover/pad.
4. Remove the cover (A), then disconnect the ODS unit 18P connector (B) from the ODS unit (C).






5. Remove the two nuts and washers (D) and the ODS unit.

Installation

1. Place the ODS unit (A) on the seat-back frame. Install the two washers and nuts, and torque the two nuts (B), and connect the ODS unit harness 18P connector (C) to the ODS unit. Reinstall the cover (D).






2. Install the seat-back cover.
3. Install the front passenger's seat assembly, then connect the side airbag harness 2P connector.
4. Do the battery terminal reconnection procedure.
5. Set the seat-back in the normal position, and make sure there is nothing on the front passenger's seat.
6. Initialize the ODS unit.
7. Confirm proper SRS operation: Turn the ignition switch to ON (II); the SRS indicator should come on for about 6 seconds and then go off.