Passenger's Middle Pad Removal/Installation
Passenger's Middle Pad Removal/InstallationSpecial Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program
SRS components are located in this area. Review the SRS component locations, 2-door, 4-door and the precautions and procedures before doing repairs or service.
NOTE:
- Take care not to scratch the dashboard, and its related parts.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
1. Do the battery terminal disconnection procedure, then wait at least 3 minutes before beginning work.
2. Remove these items:
- Center pocket:
- Without navigation system
- With navigation system
- Passenger's dashboard trim
- Dashboard center vent (with navigation system)
- Audio-HVAC module:
- Without navigation system
- With navigation system
- Passenger's dashboard side vent
- Passenger's airbag
3. Gently pull out along the edge of the passenger's middle pad (A) to detach the hooks (B), then remove the pad.
4. Install the pad in the reverse order of removal, and note these items:
- Push the hooks into place securely.
- Do the battery terminal reconnection procedure.
- Check for any DTCs that may have been set during repairs, and clear them.