Dashboard Center Lower Cover Removal/Installation

Dashboard Center Lower Cover Removal/Installation

Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program

SRS components are located in this area. Review the SRS component locations, 2-door, 4-door and the precautions and procedures before doing repairs or service.

NOTE:
- Take care not to scratch the dashboard and its related parts.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Remove the center console panel.
2. Release both front portions of the center console (A) from the dashboard.
1. Remove the screws.
2. Detach the clips by pulling the front bottom edges of the console out from both sides.
3. Gently pull up both front portions of the console to release the hooks (B) from the dashboard.






3. Remove the driver's dashboard center lower cover (A).
1. Remove the clip (B).
2. Gently pull the rear upper edge of the cover to detach the clip (C).
3. Pull up the rear portion of the cover to release the hook (D) from the rear heater duct (E).
4. Pull the cover rearward to release the hook (F) from the heater unit (G).






4. Remove the passenger's dashboard center lower cover (A).
1. Remove the clip (B).
2. Gently pull the front upper edge of the cover to detach the clip (C).
3. Pull up the cover to release the hook (D) from the rear heater duct (E).






5. Install the cover in the reverse order of removal, and note these items:
- If the clips are damaged or stress-whitened, replace them with new ones.
- Push the clips into place securely.
- Make sure the hooks are set properly.