Motor Test
Motor Test1. Remove the driver's seat.
2. Remove the power seat adjustment switch knobs and the recline cover from the seat.
3. Disconnect the 12P connector (A) from the power seat adjustment switch (B).
4. At the 12P connector of the driver's seat wire harness side, test the motor by applying battery power and ground to the terminals according to the table.
5. If the motor does not run or fails to run smoothly, go to step 6.
6. Disconnect the 2P connector from each motor.
NOTE:
- For the recline motor, remove the seat-back cover.
- All connector views are wire side of female terminals.
7. Check for continuity between each motor 2P connector and the driver's seat wire harness 12P connector. If there is continuity, replace the appropriate motor:
NOTE: The front and rear up-down motors are part of the up-down adjuster.
