Removal and Replacement
Alternator Removal and InstallationRemoval
1. Make sure you have the anti-theft codes for the audio unit (and navigation code if equipped), then write down the audio presets. Make sure the ignition switch is OFF.
2. Disconnect the negative cable from the battery first, then disconnect the positive cable.
3. Disconnect the fan motor connector (A) and compressor clutch connector (B), then remove the reserve tank (C).
4. Remove the two bolts (D), and loosen a bolt (E), then remove the A/C condenser fan shroud.
5. Remove the drive belt.
6. Disconnect the alternator connector (A) and BLK wire (B) from the alternator.
7. Remove the bolt (C) securing the harness holder.
8. Remove the mounting bolt (A) and alternator bracket mounting bolt (B), then remove the alternator.
Installation
1. Install the alternator.
2. Connect the alternator connector (A) and the BLK wire (B) to the alternator.
3. Install the harness holder (C).
4. Install the drive belt.
5. Install the condenser fan shroud (A), and reserve tank (B), then connect the fan motor connector (C) and compressor clutch connector (D).
6. Connect the positive cable to the battery first, then connect the negative cable.
7. Enter the anti-theft codes for the audio unit (and navigation code if equipped), then enter the audio presets.
8. Set the clock.