Seat Occupant Classification Module - Air Bag: Testing and Inspection
Front Passenger's Weight Sensor Unit/ODS unit CalibrationWhen the front passenger's weight sensors and/or weight sensor unit ('04-05 models) or the ODS unit ('06-07 models) is replaced, calibrate the weight sensor unit ('04-05 models) or the ODS unit ('06-07 models) by following the procedure.
While calibrating the front passenger's weight sensor unit ('04-05 models) or the ODS unit ('06-07 models), observe these precautions:
- Make sure nothing is on or under the front passenger's seat.
- Make sure there is nothing in the front passenger's seat-back pocket.
- Keep the windows closed.
- Perform all calibration procedures except test driving in the service bay.
- Make sure the vehicle is on level ground.
- Keep the A/C and the heater off.
- Do not touch the front passenger's seat until you drive the vehicle.
- Do not expose the front passenger's seat to sudden temperature changes.
1. Position the front passenger's seat to the rear most position, and adjust the recliner to the most forward position. Do not move from these positions.
2. Make sure the ignition switch is OFF.
3. Connect the HDS to the data link connector (DLC) (A).
4. Turn the ignition switch ON (II).
5. Drive the vehicle, and accelerate to 20 mph (36 km/h), then stop on level ground.
6. From the Main Menu, select SRS, then Seat Weight Sensor, then Misc Test, then Adjustments. Select "SWS UNIT" in the Adjustment Menu and follow the prompts until the initialization operation has been completed.