Side Impact Sensor (Second)
Side Impact Sensor (Second) ReplacementNOTE: Make sure the SRS unit and the impact sensors are of the same manufacturer.
Removal
1. Disconnect the battery negative cable, and wait at least 3 minutes before beginning work.
2. Disconnect the appropriate side curtain airbag 2P connector.
3. Remove the side trim panel.
4. Disconnect the side impact sensor (second) 2P connector (A) from the side curtain airbag harness.
5. Remove the TORX bolts (B) using a TORX T30 bit, then remove the side impact sensor (second) (C).
Installation
1. Install the new side impact sensor (second) (A) with the TORX bolts (B), then connect the side curtain airbag sub harness 2P connector (C) to the side impact sensor (second).
2. Reconnect the battery negative cable.
3. Install all removed parts.
4. After installing the side impact sensor (second), confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should come on for about 6 seconds and then go off.