Harmonic Balancer - Crankshaft Pulley: Service and Repair
Crankshaft Pulley Removal and InstallationSpecial Tools Required
^ Holder handle 07JAB-001020A
^ Holder attachment, 50 mm, offset 07MAB-PY3010A
^ Socket, 19 mm 07JAA-001020A, or a commercially available 19 mm socket
Removal
1. Remove the right front tire/wheel.
2. Remove the splash shield.
3. Remove the drive belt.
4. Hold the pulley with the holder handle (A) and holder attachment (B).
5. Remove the bolt with a heavy duty 19 mm socket (C) and breaker bar, then remove the crankshaft pulley.
Installation
1. Remove any oil or clean the pulleys (A), crankshaft (B), bolt (C), and washer (D). Lubricate with new engine oil as shown.
2. Install the crankshaft pulley, and tighten the bolt.
Do not use an impact wrench.
- 1 Hold the pulley with the holder handle (A) and holder attachment (B), then tighten the bolt to 64 Nm (6.5 kgf-m, 47 ft. lbs.) with a torque wrench and 19 mm socket (C).
- 2 Mark the bolt head and crankshaft pulley as shown, then tighten the bolt an additional 60° (The mark on the bolt head line up with the mark on the crankshaft pulley).
3. Install the drive belt.
4. Install the splash shield.
5. Install the right front tire/wheel.