Audio Disc Does Not Eject (Without Navigation)

Special Tools Required
- Radio test harness breakout box07AAZ-SDAA100
- Test harness (Stanley) 070AZ-SDAA200

Audio disc does not eject (without navigation)

NOTE: Inspect the quality of the Discs, and make sure there are no adhesive labels applied to them.

1. Check to see if the disc ejects correctly by pushing the EJECT button.

Is it normal?

YES - Operation is normal.

NO - Go to step 2.

2. Check to see if the disc ejects with some binding or does not eject at all.

Does the disc bind when it ejects?

YES - Go to step 3.

NO - Go to step 4.

3. Replace the disc with a different one and recheck.

Does the problem continue?

YES - Replace audio unit

NO - Faulty CD disc.

4. Remove the audio unit.
5. Connect the test harness (070AZ-SDAA200) to the radio test harness breakout box (07AAZ-SDAA100).




6. Connect the test harness connectors to the printed circuit board connector of the audio unit.
7. Connect the ohm meter to the breakout box (07AAZ-SDAA200) EJECT and GND terminals.
8. Push the EJECT button and check for continuity between the EJECT and GND terminals.

Is there continuity?

YES - Go to step 9.

NO - Replace the audio-HVAC display panel.

9. Check the connections between the audio-HVAC display panel and the audio unit.

Are the connections OK?

YES - Replace the audio unit

NO - Reinstall the audio-HVAC display panel onto the audio unit, and check the problem.