Front Door Outer Molding Replacement
Front Door Outer Molding ReplacementSpecial Tools Required
KTC trim tool set SOJATP2014*
*Available through the American Honda Tool and Equipment Program.
NOTE:
- If you remove the door outer molding, replace it with a new one because it will bend during removal.
- Put on gloves to protect your hands.
- Take care not to scratch the door.
- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
1. Remove these items:
- Mirror
- Door sash trim, 2-door
2. Remove the door outer molding (A).
1. 4-door: Pry the rear clip with a trim tool.
2. While removing the upper edge of the door outer molding from the edge of the sash, cut the double-sided adhesive tapes (B) with a utility knife, then remove the molding.
3. Scrape off the remaining double-sided adhesive tape from the sash, then clean the sash surface with a sponge dampened in alcohol.
4. Install new door outer molding in the reverse order of removal, and note these items:
- Push the clip and the adhesive portions into place securely.
- Make sure the upper and lower sides of the molding are catching the edges of the sash properly.