2. Flywheel Housing Disassembly & Service
Flywheel HousingFinal Drive Shaft Bearing Replacement
Special Tools Required
^ Adjustable bearing puller, 25-40 mm 07736-A010008 or 07736-A01000A
^ Driver 07749-0010000
^ Attachment, 62 x 68 mm 07746-0010500
1. Remove the final drive shaft bearing (A) with the special tool and a commercially available 3/8"-16 slide hammer (B).
2. Install the new bearing into the flywheel housing with the special tools.
Input Shaft Oil Seat Replacement
Special Tools Required
^ Driver 07749-0010000
^ Attachment, 37 x 42 mm 07746-0010200
1. Remove the input shaft oil seal from the flywheel housing.
2. Install the new oil seal flush with 3 ± 0.5 mm (0.12 ± 0.02 inch) (A) below flywheel housing level.