Removal And Installation
Starter Removal and InstallationRemoval
1. Make sure you have the anti-theft code for the radio or navigation system, then write down the audio presets.
2. Disconnect the negative cable from the battery first, then disconnect the positive cable.
3. Remove the battery and battery box.
4. Remove the air cleaner.
5. Remove the air intake duct.
6. Disconnect the starter cable (A) from the B terminal and the BLK/WHT harness connector (B) from the S terminal, then remove the upper radiator hose bracket (C).
7. Remove the two bolts holding the starter, then remove the starter.
Installation
1. Install the starter, then install the starter mounting bolts.
2. Connect the starter cable (A) to the B terminal and the BLK/WHT harness connector (B) to the S terminal, then install the upper radiator, hose bracket (C). Make sure the crimped side of the ring terminal is facing out.
3. Install the air intake duct.
4. Install the air cleaner.
5. Install the battery and battery box.
6. Clean the battery posts and cable terminals, then assemble them, and apply grease to prevent corrosion.
7. Start the engine to make sure the starter operates properly.
8. Do the start clutch calibration procedure.
9. Enter the anti-theft code for the radio or navigation system, then enter the audio presets.
10. Set the clock.
11. If the IMA battery level gauge (BAT) displays no segments, start the engine, and hold it between 3,500 rpm and 4,000 rpm without load (in Park or Neutral) until the BAT displays at least three segments.