Fuel Tank Unit Removal/Installation

Fuel Tank Unit Removal/Installation

Special Tools Required
Fuel pump module locknut wrench 07AAA-SNAA100

Removal

1. Remove the fuel tank.
2. Disconnect the fuel tank unit 4P connector.




3. Using the special tool, loosen the locknut (A).




4. Remove the locknut (A) and the fuel tank unit (B).

Installation




1. Install a new base gasket (A), and locknut plate (B) to the fuel tank (C).
2. Insert the fuel tank unit (D) into the fuel tank. Be careful not to bend the fuel gauge sending unit.
3. Align the marks (E) on the fuel tank and the fuel tank unit, then tighten a new locknut (F) by hand.

NOTE:
- After tightening, make sure the marks (D) is aligned. Check circumference of the base gasket visually or by hand and be sure that the gasket is not pinched.
- Do not coat the base gasket or the locknut plate with oil.




4. Using the tool, tighten the fuel tank unit locknut (A).

NOTE: After installation, check the base gasket visually or by hand to be sure the gasket is not pinched.

5. Install the fuel tank in the reverse order of removal.