CKP Sensor Replacement

CKP Sensor Replacement




1. Disconnect the CKP sensor connector (A).
2. Remove the CKP sensor (B).
3. Install the sensor in the reverse order of removal with a new O-ring (C).
4. Do the CKP pattern clear/pattern learn procedure with the HDS Below.

CKP Pattern Clear/CKP Pattern Learn

NOTE: The ECT needs to be at 176 degree F (80 degree C) or higher.

1. Clear the CKP pattern while the engine is stopped.
2. Turn the ignition switch OFF.
3. Turn the ignition switch ON (II), and wait 30 seconds.
4. Test-drive the vehicle on a level road: decelerate (with the throttle fully closed) from an engine speed of 2,500 rpm to 1,000 rpm with the A/T in 2 position, or M/T in 1st gear.
5. Stop the vehicle, but keep the engine running.
6. Check PULSER F/B LEARN in the DATA LIST with the HDS. If it is NOT COMPLETED, go to step 4. If it is COMPLETED, go to step 7.
7. Turn the ignition switch OFF.
8. Turn the ignition switch ON (II), and wait for 30 seconds. The CKP learning procedure is completed.