Rear Seat-Back Lock Cylinder

Rear Seat-back Lock Cylinder Replacement

Special Tools Required
KTC trim tool set SOJATP2014

2-door

NOTE:
- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
- Take care not to scratch the interior trim.

1. Remove the rear shelf.
2. Disconnect the cylinder rods from both seat-back latches.




3. Remove the screws, then remove the seat-back lock cylinder (A) and cylinder rods (B).
4. Install the lock cylinder in the reverse order of removal, and note these items:
- Make sure the cylinder rod is connected securely.
- Make sure the seat-back opens properly.

4-door

NOTE:
- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
- Take care not to scratch the interior trim.




1. Remove the lock cylinder trim (A).
2. From trunk compartment, disconnect the cylinder rods from both seat-back latches.




3. Remove the screws, then remove the seat-back lock cylinder (A) and cylinder rods (B).
4. Install the lock cylinder in the reverse order of removal, and note these items:
- Make sure the cylinder rod is connected securely.
- Make sure the seat-back opens properly.