Valve Body: Service and Repair
CVTLower Valve Body Assembly Removal
1. Raise the front of the vehicle, and make sure it is securely supported.
2. Set the parking brake, and block rear wheels securely.
3. Disconnect the solenoid harness connector (8P).
4. Remove the drain plug (A), and drain the automatic transmission fluid (ATF). Reinstall the drain plug with a new sealing washer (B).
5. Remove the ATF pan (A) (14 bolts).
6. Remove the ATF strainer (B) (two bolts).
7. Remove the lower valve body assembly (C) (eight bolts).
8. Remove the bolt securing the solenoid harness connector (D) with holding the lower valve body assembly, and remove the connector and valve body assembly.
Lower Valve Body Assemble Installation
1. Install the solenoid harness connector (A) with holding the lower valve body assembly (B).
2. Install the lower valve body assembly (eight bolts).
3. Install the ATF strainer (C) (two bolts).
4. Install the ATF pan (D) with the two dowel pins (E) and new gasket (F).
5. Check the solenoid harness connector for rust, dirt, or oil, then connect the connector securely.
6. Refill the transmission with ATF.
7. Perform the start clutch calibration procedure.