Oil Pan Installation
InstallationAluminum Oil Pan
1. Clean and dry the oil pan mating surfaces and bolt holes.
2. Apply liquid gasket, part No.08718-0001 or 08718-0003, evenly to the oil pan mating surface of the block and to the inner threads of the bolt holes.
NOTE:
^ Apply a 4 mm wide bead of liquid gasket.
^ Apply a second bead where the two ends of the first bead meet.
^ Do not install the parts if 5 minutes or more have elapsed since applying liquid gasket. Instead, reapply liquid gasket after removing old residue.
3. Install the oil pan.
4. Tighten the bolts in two or three steps. In the final step, tighten all bolts, in sequence to 12 Nm (1.2 kgf-cm, 8.7 ft. lbs.).
5. After assembly, wait at least 30 minutes before filling the engine with oil.
Steel Oil Pan
1. Clean and dry the oil pan mating surfaces and bolt holes.
2. Apply liquid gasket, PIN 08718-0001 or 08718-0003, on the oil pump and engine block end cover mating areas.
NOTE: Do not install the parts if 5 minutes or more have elapsed since applying liquid gasket. Instead, reapply liquid gasket after removing old residue.
3. Apply liquid gasket, P/N 08718-0001 or 08718-0003, to the new oil pan gasket (A) at the four corners of the recesses (B), then install the oil pan (C).
NOTE: Do not install the parts if 5 minutes or more have elapsed since applying liquid gasket. Instead, reapply liquid gasket after removing old residue.
4. Tighten the bolts and nuts finger tight at six points as shown.
5. Tighten all bolts and nuts, starting from nut (1), clockwise in 3 steps. In the final step, tighten all bolts, in sequence to 12 Nm (1.2 kgf-cm, 8.7 ft. lbs.).
6. After assembly, wait at least 30 minutes before filling the engine with oil.