Rear Door Panel: Service and Repair

Rear Door Panel Removal/Installation

Special Tools Required
- KTC trim tool set SOJATP2014
- Trim pad remover. Snap-on A 177A or equivalent, commercially available

4-door

NOTE: Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.




1. If applicable, remove the regulator handle (A) by pulling the clip (B) out with a wire hook (C).




2. Remove the inner handle (A). Take care not to scratch the door panel.
1. Pry out on the upper portion of the cover (B) to release the hooks (C, D), then remove the cover.
2. Remove the screws.
3. Pull the inner handle forward and out half-way to release the hook (E).
4. Disconnect the inner handle rod (F).




3. Remove the grip cover (A)
1. Using a trim tool, pry out the front edge of the cover to release the clip (B).
2. Pry out along the bottom to release the lower hooks (C).
3. Pry out along the top to release the upper hooks (D), and release the clip (E) while pulling the cover forward.
4. Remove the screws from the grip base (F).




5. Release the clips that hold the door panel (A) with a commercially available trim pad remover (B), then remove the door panel by pulling it upward, and disconnect the power window switch connector (C) (for some models). Remove the door panel with as little bending as possible to avoid creasing or breaking it.




6. Install the door panel in the reverse order of removal, and note these items:
- Replace any damaged clips
- Make sure the connectors are plugged in properly, and the rod is connected properly
- Make sure the window operates properly.
- If applicable, install the regulator handle so it points forward and up at a 45 ° angle with the glass fully closed.