Replacement
Starter Replacement1. Make sure you have the anti-theft code for the radio, then write down the frequencies for the radio's preset buttons.
2. Disconnect the negative cable from the battery first, then the positive cable.
3. Remove the air cleaner housing.
4. Remove the harness clamps (A), then remove the air cleaner housing stay (B).
5. Disconnect the starter cable (A) from the B terminal, then disconnect the BLK/WHT wire (B) from the S terminal.
6. Remove the two bolts holding the starter, then remove the stater.
7. Install the starter in the reverse order of removal. Make sure the crimped side of the ring terminal (A) is facing out.
8. Clean the battery posts and cable terminals with sandpaper, then assemble them and apply grease to prevent corrosion.
9. Start the engine to make sure the starter operates properly.
10. Perform the engine control module (ECM) idle learn procedure.
11. Enter the anti-theft code for the radio, then enter the customer's radio station presets.