Front Passenger's Weight Sensor Replacement

Front Passenger's Weight Sensor Replacement

Removal

NOTE: Removal of the front passenger's weight sensors must be performed according to the precautions/procedures described. For service information refer to Body and Frame / Seats / Service and Repair.

1. Remove the seat assembly.

2. Remove the tamper-resistant Torx bolts attaching the seat to the weight sensors.






2-door

4-door

3. Remove the front passenger's weight sensors from the seat riser.


Installation

NOTE: Be sure to install the harness wires so they are not pinched or interfering with other parts.

1. Place the new front passenger's weight sensors on the seat riser.

2. Install the seat onto the weight sensors.

3. Reinstall the seat assembly.

4. Reconnect the battery negative cable.

5. Calibrate the front passenger's weight sensor unit.

6. After installing the front passenger's weight sensors, confirm proper system operation: Turn the ignition switch ON (II): the SRS indicator should come on for about 6 seconds and then go off.