Engine Control Module: Service and Repair
How to Remove the ECM for TestingNOTE:
- Make sure you have the anti theft code for the radio, then write down the frequencies for the radio's preset buttons before you disconnect the negative cable from the battery.
- Enter the anti theft code, then enter the customer's radio station presets, and set the clock after you reconnect the negative cable to the battery.
If the inspection for a trouble code requires voltage or resistance checks at the ECM connectors, remove the ECM and test it.
1. Disconnect the negative cable from the battery.
2. Remove the left side kick panel (A) to expose the ECM (B).
3. Remove the two bolts from the ECM (B).
4. Disconnect the ECM connectors.
5. Install the ECM in the reverse order of removal.
6. Reconnect the negative cable to the battery.
7. Do the idle learn procedure.
How to Replace the ECM
1. Turn the ignition switch OFF.
2. Remove the left side kick panel (A) to expose the ECM (B).
3. Remove the two bolts from the ECM.
4. Disconnect the ECM connectors.
5. Install the ECM in the reverse order of removal.
6. Connect the HDS to the DLC (A) located under the passenger's side of dashboard ('00-01 models) or behind the driver's side of the front console ('02-04 models).
7. Turn the ignition switch ON (II).
NOTE: If DTC P0630 "VIN Not Programmed or Mismatch" is stored at this time, ignore it and continue this procedure.
8. Input the VIN to the ECM with the HDS.
9. Rewrite the immobilizer code with the ECM replacement procedure in the HDS; it allows you to start the engine.
10. Reset the ECM with the HDS.
11. Do the idle learn procedure.