Disassembly

Disassembly

Special Tools Required
^ Clutch spring compressor attachment 07LAE-PX40100
^ Clutch spring compressor attachment 07HAE-PL50100
^ Clutch spring compressor bolt assembly 07GAE-PG40200 or 07GAE-PG4020A





1. Remove the snap ring (A), then remove the clutch end plate, the clutch discs, and the plates with a screwdriver (B).





2. Remove the disc spring.





3. Install the special tool on the clutch assembly.





4. Be sure the special tool (A) is adjusted to have full contact with the spring retainer (B) on the clutch.





5. If either end of the special tool is set over an area of the spring retainer which is unsupported by the return spring, the retainer may be damaged.





6. Compress the spring until the snap ring can be removed.





7. Remove the snap ring (A). Then remove the special tools (B), spring retainer (C), and return spring.





8. Wrap a shop rag around the clutch drum (A), and apply air pressure to the fluid passage to remove the piston (B). Place a finger tip on the other end while applying air pressure.