Lower Valve Body Removal and Installation

Lower Valve Body Removal and Installation
1. Raise the front of the vehicle, and make sure it is securely supported. Set the parking brake, and block rear wheels securely. Or lift up the vehicle.
2. Remove the air cleaner housing and intake air duct.
3. Disconnect the solenoid harness connector.





4. Remove the under-cover.





5. Remove the drain plug (A), and drain the automatic transmission fluid (ATF). Reinstall the drain plug with a new sealing washer (B).





6. Remove the ATF pan (A).
7. Remove the ATF strainer (B).
8. Remove the bolts securing the lower valve body (C), and remove the bolt securing the solenoid harness connector (D) with holding the lower valve body, then remove the lower valve body.
9. Install the lower valve body reverse order of removal.
10. Refill the transmission with ATF.
11. Calibrate the start clutch pressure control system if any control valve of the lower valve body is replaced.