Replacement
Starter Replacement1. Make sure you have the anti-theft code for the radio, and the navigation system, then write down the frequencies, for the radio's preset buttons.
2. Disconnect the negative cable from the battery first, then disconnect the positive cable.
3. Remove the battery.
4. Remove the harness clamp (A).
5. Disconnect the starter cable (B) from the B terminal, then disconnect the BLK/WHT wire (C) from the S terminal.
6. Remove the two bolts holding the starter, then remove the starter.
7. Install in the reverse order of removal. Make sure the crimped side of the ring terminal is facing out.
8. Connect the battery positive cable and negative cable to the battery.
9. Start the engine to make sure the starter works properly.
10. Enter the antitheft codes for the radio and the navigation system, then enter the customer's radio station presets.
11. Set the clock.
12. Perform the power window control unit reset procedure.