Start-Up Procedure and Diagnosis Menu

Start-up procedure and Diagnosis Menu

1. Turn the ignition switch to the ON (II) position.

A. If the battery has not been disconnected, then press and hold Menu, Map/Guide, and Cancel buttons. Keep them pressed for approximately 5 seconds. The display screen then goes directly to the Diagnostic Menu.

B. If the battery was disconnected and reconnected prior to this test and you do not have the anti-theft security code or the "Acquiring GPS Reception" screen is displayed, hold down the Menu arid Zoom Out button. You will see the "Navi System Link" screen. Push the joystick to go directly to the Diagnostic Menu.

NOTE: This only allows access to the diagnostic screens. All other Navigation functions are disabled.

2. After the display changes to the Diagnostic Menu, select the item you want to check, and the test will start. To return to the previous screen, select "Return".

- Navi System (Link)
- F-CAN (System Link)
- B-CAN (System Link)
- Monitor Check
- Unit Check
- Car Status
- GPS Information
- Yaw Rate
- Tire Calibrate
- Functional Setup
- Version