Descriptions
DescriptionsKey Cylinder Operation
With the key inserted in the driver's door key cylinder, turn the key a second time and hold within 10 seconds to operate the windows (clockwise to open, counterclockwise to close). The windows stop moving when the key is released.
NOTE: Anti-trap will not work when door key cylinder switch is used to close the windows.
Keyless Operation
By pressing the UNLOCK button of the keyless transmitter a second time and holding,the windows open. The windows stop moving when the UNLOCK button is released. The windows do not close with the LOCK button.
Anti-trap Power Window Operation
The system is composed of the power window master switch, the power window master switch and the driver's window motor. The power window motor incorporates a pulser which generates pulses during the motor's operation and sends the pulses to the power window control unit. As soon as the power window master switch detects no pulses from the pulser, the control unit makes the power window motor stop and reverse. This is to prevent pinching your hand or fingers during auto-up operation.
Resetting the power window
Resetting the power window is required when any of the following have been removed or repaired
- Power window regulator
- Window run channel
- Power window motor
- Door glass
Using the HDS
1. Connect the Honda Diagnostic System (HDS) to the vehicle's DLC.
2. Turn the ignition switch ON (II), then enter the vehicle's VIN and mileage at the prompts.
3. Select Body Electrical from the System Selection menu.
4. From the Body Electrical System Select menu, select Power Windows.
5. From the Mode menu, select Adjustments.
6. From the Adjustment menu, select Window P Reset.
7. Follow the prompts on the screen.
8. Confirm that the power window master switch is reset by using the driver's window AUTO UP and DOWN function.
Resetting the power window
Without the HDS
1. Turn the ignition switch ON (II).
2. Move the driver's window all the way down by using the driver's window DOWN switch.
3. Open the driver's door.
NOTE: Steps 4-7 must be done within 5 seconds of each other.
4. Turn the ignition switch OFF.
5. Push and hold the driver's window DOWN switch.
6. Turn the ignition switch ON (II).
7. Release the driver's window DOWN switch.
8. Repeat steps 4-7 three more times.
9. Wait 1 second.
10. Confirm that AUTO UP and AUTO DOWN do not work If AUTO UP and DOWN work, go back to step 1.
11. Move the driver's window all the way down by holding the driver's window DOWN switch to the AUTO DOWN position.
12. Pull up and hold the driver's window UP switch to the AUTO UP position until the window reaches the fully closed position, then continue to hold the switch for 1 second.
13. Confirm that the power window master switch is reset by using the driver's window AUTO UP and DOWN function.
If the window still does not work in AUTO, repeat the procedure several times, paying close attention to the 5 second time limit between steps. If it still does not work, go to B-CAN System Diagnosis Test Mode A.