Body - Moonroof Doesn't Close Completely
03-003July 2, 2004
Applies To:
See VEHICLES AFFECTED
Updated information is shown by asterisks.
Moonroof Does Not Close Completely
(Supersedes 03-003, dated June 24, 2003)
SYMPTOM
The moon roof does not close completely unless you press the moonroof switch repeatedly.
PROBABLE CAUSE
The moonroof limit switch is faulty.
VEHICLES AFFECTED
2003 Accord L4 4-Door EX:
From VIN 1HGCM5. ..3A000001 thru
1HGCM5...3A017403
From VIN JHMCM5. ..3C000001 thru
JHMCM5...3C028190
2003 Accord V6 4-Door EX:
From VIN 1HGCM6. ..3A000001 thru
1HGCM6...3A012934
CORRECTIVE ACTION
Replace the moonroof limit switch.
PARTS INFORMATION
Moonroof Limit Switch:
P/N 70431-SEA-A01, H/C 7359607
WARRANTY CLAIM INFORMATION
In warranty:
The normal warranty applies.
Operation Number: 814134
*Flat Rate Time: 1.1 hours*
Failed Part: P/N 70200-SDC-A01
H/C 7248966
*Defect Code: 03214
Symptom Code: 03220*
Template ID: 03-003A
Skill Level: Repair Technician
Out of warranty:
Any repair performed after warranty expiration may be eligible for goodwill consideration by the District Parts and Service Manager or your Zone Office. You must request consideration, and get a decision, before starting work.
REPAIR PROCEDURE
*1. Remove the headliner. See page 20-103 of the 2003-04 Accord Service Manual. (In ISIS, use the keyword HEADLINE, and select Headliner Removal/Installation from the list.) Use a trim pad remover to unfasten the headliner clips.*
2. Mark the position of the moonroof limit switch.
3. Unplug the 4P connector from the limit switch. Remove the two mounting bolts, then remove the switch.
4. Install the new limit switch with the two mounting bolts, making sure the new switch is in the same position as the original switch. Torque the bolts to 5 N.m (4 lb-ft). Plug in the 4P connector.
5. Turn the ignition switch to ON (II), and check the operation of the moonroof with the moon roof switch (from the tilt-up position to fully closed; from the fully open position to fully closed).
* ^ If the moonroof does not work properly, adjust the limit switch (see page 20-86). (In ISIS, use the keyword LIMIT, and select Moonroof Limit Switch Adjustment from the list.) Reinstall the headliner.*
^ If the moonroof works properly, reinstall the headliner.
Disclaimer