Rear Seat-Back Latch Replacement

Rear Seat-back Latch Replacement

2-door

NOTE:
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
- Take care not to bend or scratch the interior trim.

1. Remove the rear shelf cover.




2. Disconnect the cylinder rod (A), remove the bolts, then remove the seat-back latch (B).
3. Install the latch in the reverse order of removal, and note these items:
- Make sure the cylinder rod is connected securely.
- Make sure the seat-back locks securely and unlocks properly.

4-door

NOTE:
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
- Take care not to bend or scratch the interior trim.

1. Remove these items:
- Rear door sill trim, both sides.
- Seat side bolster, both sides.
- Rear shelf cover.




2. Disconnect the cylinder rod (A) from the trunk compartment.




3. Remove the bolts, then remove the seat-back latch. Fastener Locations.
4. Install the latch in the reverse order of removal, and note these items:
- Make sure the cylinder rod is connected securely.
- Make sure the seat-back locks securely and unlocks properly.