Body/Frame - Subframe Removal Adapter
02-066November 19, 2002
Applies To:
2003 Accord - ALL
Accord Subframe Removal Adapter
When properly fitted to the transmission jack and the the vehicle's subframe, the adapter allows the subframe to be removed for transmission repair.
ORDERING INFORMATION
One Subframe Adapter (T/N VSB02C000016) was shipped to each dealership as a required special tool.
To order an additional adapter, call the Honda Tool and Equipment Program.
USING THE ADAPTER
NOTE:
The subframe removal adapter is for subframe support only. It will not support the engine, transmission, and subframe as one assembly. Read the labels on the subframe adapter.
1. Remove the bolts from the transmission jack. Line up the slots in the four adjustable arms of the adapter with the bolt holes on the corners of the transmission jack base, then bolt on the adapter.
2. Remove the safety pin that holds the strap, and loosen the two L-shaped brackets.
3. Raise the jack until the adapter touches the subframe.
4. Loosen the wing nut that tightens the strap.
5. Adjust the position of the transmission jack or the subframe adapter as necessary so that the adapter presses flat against the subframe.
6. With the rear of the adapter spanning the sides of the subframe, wrap the strap around the front of the subframe. Pull the strap tight, then insert the safety pin in the adapter and a loop in the strap. Make sure the pin goes through a loop in the strap, not between the loops.
7. Finger-tighten the wing nut that tightens the strap. Do not overtighten; the strap only needs to be snug.
8. Slide the adjustable L-shaped brackets against the subframe, and tighten the adapter bolts.
9. With all vehicle parts properly supported or removed, remove the subframe mounting bolts and lower the subframe. See Transmission Removal in section 14 or Steering Gearbox Removal in section 17 of the 2003 Accord Service Manual.
Disclaimer