Operation CHARM: Car repair manuals for everyone.
Hosted by mcallihan.com

Fog Light Lens - Cracked/Damaged

01-063

July 24, 2001

Applies To:
2001 Accord ALL
2001 Civic - ALL

Fog Light Lens Is Cracked or Damaged

SYMPTOM

The fog light lens is cracked or damaged.

PROBABLE CAUSE

Irregularities in the contact area between the fog light lens and the fog light body stress the lens. The lens may crack after it is heated during fog light operation and then exposed to cold water such as rain or a car wash.

CORRECTIVE ACTION

Replace the fog light assembly with an improved part.

PARTS INFORMATION

Fog Light Assembly, Left Side:
P/N 08V31-55D-1M102, H/C 6837728

Fog Light Assembly, Right Side:
P/N 08V31-S5D-1M101, H/C 6837710

WARRANTY CLAIM INFORMATION

In warranty:
The normal warranty applies.

Operation Number: 019104

Flat Rate Time: 0.5 hour

Failed Part: P/N 08V31-584-100G H/C 6498448

Defect Code: 017

Contention Code: AO1

Template ID: 01-063A

Skill Level: Repair Technician

Out of warranty:
Any repair performed after warranty expiration may be eligible for goodwill consideration by the District Service Manager or your Zone Office. You must request consideration, and get a decision, before starting work.

DIAGNOSIS

Examine the fog light housing and surrounding areas to verify that the damage was not caused by an impact from road debris. A cracked lens may appear to have been by road debris, but if there is no damage to the surrounding areas, replace both fog light assemblies with the improved parts.

REPAIR PROCEDURE

1. For the Accord 2-door only, remove the fog light cover.





2. Remove the mounting screws that secure the fog light assembly to the vehicle.





3. Partially remove the fog light assembly to expose the connector; then disconnect the connector, and remove the fog light assembly from the vehicle.

4. Transfer the mounting hardware from the old tog light to the new fog light.

5. Reconnect the connector, and install the new fog light assembly in the vehicle.

6. For the Accord 2-door only install the fog light cover.

7. Repeat steps 1 thru 6 for the other fog light.

8. Aim the fog lights to comply with local regulations.