Secondary Shaft Preload Adjustment

Adjustment





1. Install the oil guide plates shim (A) and the bearing outer race (B) on the transmission housing (see step 16).
2. Install the rear cover, then tighten the 8 mm flange bolts in a crisscross pattern in several steps.
8 x 1.25 mm 27 Nm (2.8 kgf-m, 20 ft. lbs.)
3. Rotate the secondary shaft in both directions to seat the tapered roller bearing.





4. Measure the turning torque of the secondary shaft by rotating it in both directions with a torque wrench.
Standard: 1.86 - 2.84 Nm (19 - 29 kgf-cm, 16.5 - 25.2 inch lbs.)
5. If the preload is not within the standard, select a shim that will provide correct preload.





Shim